ARM-BELT 8N3307 - Caterpillar

Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.Problem
Reports have been received that the ignition key switch cover may become loose on the machines listed above. This may result in the ignition switch cover and key switch pulling out of the main cab control panel while removing or turning the key.Solution
Illustration 1 g06345529
(A) 352-9265 CoverUntil a permanent solution is known, glue the cover (A) back into panel with Loctite 401.In the event of failure, report the failure through the "CPI feedback" tool in Service Information Management System (SIMSi). Reference CPI number 424850 in the request. Take a picture of the condition prior to repair and attach to the report.