ARM 9D1183 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     439-3938     Link Bracket     1    
B     -     Guide Bolt
(M12 X 1.75 by 120 mm)     1    
C     9S-3263     Thread Lock Compound     1    
Illustration 1 g01152630
Raise the temperature of ring gear (3) .Note: Do not use a torch to heat the ring gear.
Position ring gear (3) on flywheel (2) with the part number toward the crankshaft. Use a soft hammer in order to seat the ring gear against the shoulder of the flywheel. Allow the ring gear to cool.
Install Tooling (B) in the crankshaft.
Attach Tooling (A) and a suitable lifting device to flywheel (2) . The weight of flywheel (2) is approximately 27 kg (60 lb).
Position flywheel (2) on Tooling (B) .
Apply Tooling (C) to the threads of bolts (1) .
Install bolts (1) . Remove Tooling (B) and install remaining bolt (1) . Tighten bolts (1) to a torque of 120 20 N m (89 15 lb ft).
Check the flywheel runout. Refer to Testing and Adjusting, "Flywheel - Inspect".