ARMATURE AS 3T0867 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1U-6396 O-Ring Assembly Compound 1
B 344-7057 Radiator Service Kit 3
C 344-7059 Radiator Grommets 3 Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 1 g01702235
Illustration 2 g01702355
Install new seals (19) from Tooling (B) to cores (14).
Install seals (17) from Tooling (C) to top radiator tank (16). Use Tooling (A) in order to lubricate seals (17).
Install seals (18) from Tooling (C) to bottom radiator tank (15). Use Tooling (A) in order to lubricate seals (18).
Install radiator cores (14) to top radiator tank (16) of the radiator assembly.
Install bottom radiator tank (15) to the radiator assembly.
Loosely install bolts and new locking nuts (12) and then install bolts and new locking nuts (13) to the bottom radiator tank.
Install support bracket (21) from the radiator assembly. Loosely install bolts and new locking nuts (20).
Tighten bolts and locking nuts (12) and then tighten bolts and locking nuts (13) to a torque of 22 N m (16 lb ft). Note: The bottom radiator tank should be square to the radiator assembly on tightening of the bolts and locking nuts.
Tighten bolts and locking nuts (20) to a torque of 22 N m (16 lb ft).
Illustration 3 g01701154
Install the air to air charge cooler (2) to radiator assembly (1).
Install bolts (10) and bolts (11) (not shown).
Tighten bolts (10) and bolts (10) to a torque of 22 N m (16 lb ft).
Illustration 4 g01699293
Position bottom cowling (4) onto radiator assembly (1). Loosely install bolts (3).
Position bottom cowling (9) onto radiator assembly (1). Loosely install bolts (5) (not shown) and bolts (6).
Loosely install bolts (7) (not shown) and bolts (8).
Tighten bolts (5) (not shown), bolts (6), bolts (7) (not shown), and bolts (8) to a torque of 9 N m (80 lb in). End By:
Install the radiator. Refer to Disassembly and Assembly, "Radiator - Install".