AXLE G DR 0685216 - Caterpillar

Basic Instructions
Follow these basic instructions whenever you are operating the machine:
To prevent injury, make sure that no one is working on the machine or near the machine. Always maintain control of the machine
Raise the bucket or the work tool enough to negotiate any obstacles
Before you disengage the parking brake, depress the service brake pedal in order to keep the machine from moving
Reduce the engine speed when you maneuver in tight quarters and when you are going over a hill
When you drive downhill, use the same gear range that is used for driving uphill. Do not change gears while you travel downhill
Do not allow the engine to overspeed while you travel downhill. Apply the service brake in order to reduce the engine speed
Illustration 1 g02799008
Frequently observe alert indicators, and gauges (1) and messages and warnings (2). All gauges should be at normal operating range. The alert indicators, the action lamp, and the action alarm should be off.
Adjust the operator seat.
Fasten the seat belt.
Raise the bucket approximately 400 mm (15 inch) above the ground.
Illustration 2 g02799010
Depress service brake pedal (4) .
Move parking brake control (3) to the OFF position to disengage the parking brake.
Illustration 3 g02799011
Move steering and transmission lock lever (7) to the UNLOCKED position. Move transmission direction control switch (8) to the desired travel direction. Push transmission upshift switch (6) to select the desired speed.
Release service brake pedal (4) .
Depress throttle pedal (5) to the desired engine and machine speed.Operator Present Strategy
In order to prevent the engine stopping, parking brake engaging, and implement and steering functions neutralizing, perform one of the following actions within 3 seconds:
Apply the service brake
Maintain engine speed above 850 rpm
Maintain ground speed above 5 km/h (3.1 mph)Stationary Machine (Parking Brake Released)
In order to prevent the engine stopping, parking brake engaging, and implement and steering functions neutralizing, perform one of the following actions within 3 seconds:
Apply the service brake
Maintain engine speed above 850 rpm
Engage the parking brakeAlso, to operate the steering and implement functions with the parking brake engaged perform the following action.
Maintain engine speed above 1500 rpm.Note: The operator present function engine stop can be configured using Caterpillar Electronic Technician (ET) service tool. The engine will stop when ENABLED. The engine will not stop when DISABLED.Note: If the operator present strategy stops the engine, refer to Operation and Maintenance Manual, "Engine Starting".Maneuvering in Tight Quarters
When maneuvering the machine at less than 5 km (3.1 mph), slightly depress the service brake pedal in order to prevent the operator present strategy from engaging the parking brake and stopping the engine.Fueling the Machine
To avoid possible injury or death, do not smoke while in an area that contains flammable liquids.All fuels, most lubricants, and some coolants are flammable.Keep all fuels and lubricants stored in properly marked containers and away from unauthorized persons.Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire.Store all oily rags or other flammable materials in a protective container in a safe place.Remove all flammable materials such as fuel, oil, and other debris before