AXLE & MTG GP-DRIVE 1172656 - Caterpillar

1172656 AXLE & MTG GP-DRIVE Caterpillar parts CS-531C, CS-573C, CS-583C

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1172656
117-2656
1172656

Buy AXLE & MTG GP-DRIVE 1172656 Caterpillar genuine, new aftermarket tractor parts with delivery
VIBRATORY COMPACTOR,

Compatible equipment models: 1172656:

VIBRATORY COMPACTOR CS-531C CS-573C CS-583C Caterpillar

Number on catalog scheme:

Caterpillar 1172656 Parts scheme AXLE & MTG GP-DRIVE

For full view, you need register

Information:

Illustration 1 g02477936
Connections of the Backlight Control circuit
This diagnostic code is associated with the Backlight Control circuit. The backlight lamps are used in the wiper panel, HVAC panel, and the powered mirrors switch. The FMI 03 means that the Machine ECM has determined that the voltage of the backlight control circuit is above normal.The possible causes of this diagnostic code are listed below:
There is an open in the control circuit.
The control circuit is shorted to another voltage source.
The backlight lamp assembly has failed.
The ECM has failed. This condition is unlikely.Note: Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, that all connections are secure and that all connections are in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code has been corrected.Test Step 1. CHECK THE CONTROL CIRCUIT FOR AN OPEN CIRCUIT
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector from the wiper panel, HVAC panel, and powered mirrors switch.
At the machine harness connector for wiper panel, connect a jumper wire from the signal contact 1 (wire 600-BR(Brown)) to frame ground.
Turn the key start switch and the disconnect switch to the ON position.
Observe the status of the active CID 1052 FMI 03 diagnostic code. Expected Result:The active CID 1052 FMI 03 diagnostic code is no longer active. A CID 1052 FMI 04 diagnostic code becomes active when the signal wire is grounded.Results:
YES - The active CID 1052 FMI 03 diagnostic code is no longer active. A CID 1052 FMI 04 diagnostic code has been activated after the signal wire is grounded.