AXLE AR-OSCILLATING 1400399 - Caterpillar

Component Identifier Numbers
030 - Steer Mode Selection Sensor031 - Front Steer Position Sensor032 - Rear Steer Position Sensor033 - Vehicle Propel Handle Sensor034 - Rotor Depth Position Sensor035 - Engine Speed Sensor040 - Manual Rear Steer Switch041 - F/R Direction Switch042 - Parking Brake Switch043 - Rotor Lift Lock Switch 044 - Rotor Depth Mode Switch045 - Rotor On/Off Switch046 - Rotor Raise/Lower Switch047 - Rotor Speed Selector Switch048 - Rotor Height/Travel Speed Selector Switch050 - Forward Propel Pump EDC051 - Reverse Propel Pump EDC052 - Rotor Raise Solenoid053 - Rotor Lower Solenoid054 - Right Rear Steer Solenoid055 - Left Rear Steer Solenoid056 - Parking Brake Solenoid057 - Rotor Brake Solenoid058 - Rotor Clutch Solenoid059 - Fuel Solenoid Relay060 - Battery Voltage- No Faults Stored or ActiveEnd - Indicates end of CID/FMI numbers that are stored in the ECM while scrolling A flashing red LED with no number displayed indicates the ECM has internal failure. Replace the ECM.FMI (Failure Mode Identifier) Number Definitions
F00 - Signal wire shorted to battery positive, open circuit, or sensor failure.F01 - Signal wire shorted to ground or sensor failure.F03 - Coil power wire shorted to battery positive.F05 - Coil power wire open circuit or failed coil.F06 - Coil power wire shorted to ground or failed coil.F12 - Switch signal wire shorted to positive, negative or open circuit.F13 - Sensor out of calibration. Check sensor mounting and recalibrate. Mode 2 - Calibration Mode Press switch (24) momentarily again and you will be in the calibration mode (Mode 2). Move display mode switch (25) up to increment or down to store. For more information on the calibration mode, see the Service Manual.Calibration Mode Component Identifier Numbers
Move the display mode switch to INCREMENT to scroll through component identifiers. Move the display mode switch to STORE to enter the sensor position. The amber LED will flash once if the ECM accepts the "stored" value. The red LED will flash once if the ECM rejects the "stored" value. C01 through C06 calibration with key ON and engine not running.C01 - Propel Lever - Maximum speed positionC02 - Propel Lever - Minimum speed positionC03 - Steering Mode Switch - Front steer positionC04 - Steering Mode Switch - Coordinated steer positionC05 - Steering Mode Switch - Crab steer positionC06 - Steering Mode Switch - Rear steer position C10 through C20 with engine running at high idle and machine on level solid ground.C10 - Rotor Height - Maximum up positionC11 - Rotor Height - Ground contact positionC12 - Front Wheels - Full rightC13 - Front Wheels - Centered/straightC14 - Front Wheels - Full leftC15 - Rear Wheels - Full rightC16 - Rear Wheels - Centered/straightC17 - Rear Wheels - Full leftC19 - Propel Lever - Minimum speed in forward propelC20 - Propel Lever - Minimum speed in reverse propelRotor Door Position Indicator
This indicator shows the position of the rotor door.Auxiliary Service Hour Meter
Service Hour Meter - Indicates the number of hours the engine has run.CMS Display And Automatic Set Point Switch
Travel