AXLE GP-FIXED 2318222 - Caterpillar

Rollover Protective Structure (ROPS)
Retighten the Bolts
Look for any loose or damaged bolts. Replace damaged bolts or missing bolts with original equipment parts only. Retighten bolts to a torque of 1350 175 N m (1000 120 lb ft).Do not straighten or repair by welding reinforcement plates to the ROPS.Contact your Caterpillar dealer for repair of cracks in welds, castings or any metal section on the ROPS.Lift Cylinder Yoke Bearings
Lubricate the Fittings
Fittings are located on the left front and right front sides of the machine. Lubricate the fitting on each side of the machine.Power Train Oil System
Change Oil and Wash Breather
Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin.
1. Remove the power train oil drain plug under the case. Drain the oil into a container.2. Clean and install the drain plug. 3. Open the oil fill cap access door on the left side of the machine. 4. Remove the oil fill cap.5. Add the oil. See "Refill Capacities."6. Clean and install the oil fill cap.7. Maintain the oil level to the FULL mark on the dipstick. 8. Unscrew and remove the breather on the rear of machine.9. Wash the breather in clean, nonflammable solvent.10. Install the breather.Winch (If Equipped)
Change Oil and Wash Breather
Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin.
1. Remove the oil fill plug. 2. Remove the drain plug. Allow the oil to drain into a container.3. Inspect the plug seal and replace if necessary.4. Clean and install the drain plug. 5. Fill the oil compartment until oil is visible in the sight gauge. See "Refill Capacities."6. Clean and install the fill plug.7. With the engine running at LOW IDLE, maintain the oil level so that it is visible in the sight gauge.8. Remove the breather on top of winch case. Wash it in clean, nonflammable solvent and install.