AXLE AR-OSCILLATING 2337255 - Caterpillar

Removal Procedure
Start By:
Remove the main control valve.
Table 1
Required Tools
Tool Part Number Part Description Qty
ZZ 6V-9508 Face Seal Plug 6
6V-9829 Cap As 6 Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR IN THE INSTALLATION. THIS INFORMATION IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.Reference: Refer to Disassembly and Assembly, "Main Control Valve - Remove" in this manual.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contamination of the hydraulic system with foreign material will reduce the service life of the hydraulic system components.To prevent contaminants from entering the hydraulic system, always plug or cap the lines, fittings, or hoses as they are disconnected. Cover any disassembled components and clean them properly before assembly.Clean the hydraulic system properly after any major component exchange or especially after a component failure, to remove any contamination.
Note: A hydraulic oil sample should be obtained before any maintenance is performed in order to establish the system contaminant level. Refer to Fluid Analysis Laboratory Guide, SEBF3116, "Obtaining an Oil Sample for S O S Analysis". Refer to Operation and Maintenance Manual, "Sampling Interval and Location of Sampling Valve" for the correct location.
Illustration 1 g00717357
Remove two hose assemblies (1) from the flow divider valve.
Remove sensor (4).
Remove two hose assemblies (5).
Attach a hoist and a lifting strap to the flow divider valve.
Remove seven bolts (2) that hold the flow divider valve onto the main control valve.
Remove flow divider valve (2). The weight of the flow divider valve is 64 kg (140 lb).