AXLE AR-FIXED 3002029 - Caterpillar

3002029 AXLE AR-FIXED Caterpillar parts R1600G

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA3002029
300-2029
3002029

Weight: 3150 pounds 1428 kg.

Buy AXLE AR-FIXED 3002029 Caterpillar genuine, new aftermarket tractor parts with delivery
LOAD HAUL DUMP,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

16 May 2018
1 Hundredths Pounds
SMARTRAC: SMARTRAC

SMARTRAC 3002029 Ultra High Frequency Wet Belt Monza 5 Size 73 x 17 mm - 14983 item(s)

13 Feb 2019

SMARTRAC: SMARTRAC

SMARTRAC 3002029 Ultra High Frequency Wet Belt Monza 5 Size 73 x 17 mm - 15000 item(s)
RFBand: 930 MHz;

This part in 4 request: Show. This information for suppliers only!

2023-09-13

2023-02-27

2022-11-21

2022-02-17

Number on catalog scheme:

Caterpillar 3002029 Parts scheme AXLE AR-FIXED

For full view, you need register

Compatible equipment models: 3002029:

LOAD HAUL DUMP R1600G Caterpillar

Information:

Illustration 1 g03698363
Table 1
Specification for 349-6214 Water Pump Gp
Item Qty Part Specification Description
B 1 336-2212 Water Pump Seal As Height of the water pump seal assembly after installation is 9.90 0.38 mm (0.390 0.015 inch).
1 1 229-5472 Bearing Locknut Torque to 300 30 N m (221 22 lb ft).
Use the following procedure in order to tighten the set screws for the bearing locknut :
1. Tighten the set screws in 180 degrees pattern to 4.00 1.25 N m (35.40 11.06 lb in).
2. Again, tighten the set screws in 180 degrees pattern to 7.2 0.2 N m (63.7 1.8 lb in).
2 1 235-4541 Impeller Bore in the impeller for new shaft is 25.350 0.012 mm (0.9980 0.0005 inch).
3 1 262-4379 Pump Shaft Diameter of the pump shaft for impeller is 25.400 to 25.410 mm (1.0000 to 1.0004 inch).
Lubricate the shaft lightly with clean engine oil before pressing the impeller on the pump shaft.
During assembly, pump shaft must be flush with the face of the impeller within 0.15 mm (0.006 inch).
4 1 235-4645 Lip Type Seal During assembly, Install the lip type seal dry into the pump housing. Install the lip type seal within 2 minutes after the lip type seal has been removed from the shipping tube. Use the correct installation tool. Do not use hand pressure to install water pump seal.
5 1 259-4596 O-Ring Seal Lubricate with P-80 or 5P-3975 Rubber Lubricant.