AXLE AS-UNDERCARRIAGE 4209901 - Caterpillar

4209901 AXLE AS-UNDERCARRIAGE Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA4209901
420-9901
4209901

Caterpillar 4209901 AXLE AS-UNDERCARRIAGE

Weight: 146 pounds 66 kg.

Buy AXLE AS-UNDERCARRIAGE 4209901 Caterpillar genuine, new aftermarket tractor parts with delivery

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

AS ONE Pipe Cleaner (PBT Hair) 500 x 135 x φ 10 mm White / 4-2099-01

$48.80

22 Mar 2024

JP: A1 int SHOP

AS ONE Pipe Cleaner (PBT Hair) 500 x 135 x φ 10 mm White / 4-2099-01
AS ONE Products will be exported from Japan. || When we have the items in stock, lead time will be a few weeks. || No stock products need more weeks. || MADE IN JAPAN

Number on catalog scheme: 1

Caterpillar 4209901 Parts scheme AXLE AS-UNDERCARRIAGE

For full view, you need register

Information:

Table 1
Module Contact Wire
Machine ECM J1-10 944-OR
Monitoring System ECM 8 944-OR
Engine ECM 23 944-OR
Machine Security System 12 944-OR
Product Link 5 944-OR
LH Operator ECM J1-10 944-OR
Implement (Screed) ECM J1-10 944-OR
Measure the resistance from connector J1-20 (wire 945-BR) of the RH Operator ECM to the corresponding connector contacts:
Table 2
Module Contact Wire
Machine ECM J1-20 945-BR
Monitoring System ECM 9 945-BR
Engine ECM 24 945-BR
Machine Security System 11 945-BR
Product Link 6 945-BR
LH Operator ECM J1-20 945-BR
Implement (Screed) ECM J1-20 945-BR Expected Result:The resistance that is measured is less than 5 ohms for each measurement.Results:
OK - The resistance that is measured is less than 5 ohms for each measurement. The data link circuit is correct. The ECM may have failed.Repair: Failure of the ECM is unlikely. Exit this procedure and perform this diagnostic code procedure again.Prior to replacing an ECM, always contact the Technical Communicator for your dealer for possible consultation with Caterpillar. This consultation may greatly reduce repair time. If the cause of the diagnostic code is not found and the ECM must be replaced, refer to Troubleshooting, "Electronic Control Module (ECM) - Replace".STOP
NOT OK - The resistance that is measured is greater than 5000 ohms for one or more of the measurements. The machine harness has failed.Repair: The data link circuit is open in the machine harness. Repair the machine harness or replace the machine harness. Verify that the repair eliminates the problem.STOP