AXLE GP-REAR 5076753 - Caterpillar

Illustration 1 g00594074
VIDS Display Components (1) Quad Gauge Module (2) Gauges (3) Message Center (4) Alert Indicator (5) Warning Area (6) Universal Gauge (LED) (7) Message Area (8) Status Icons (9) Keypad (10) "Cancel" Key (11) "More" Key (12) "OK" KeyACTIVE maintenance events are shown in message area (7). A maintenance event is specified by showing that a parameter has an "ERR" and instructions for the operator such as "CALL SHOP". When multiple ACTIVE maintenance events are present each event will be displayed on the message area. The message area scrolls through the events at three second intervals. The following display is shown when the hydraulic oil temperature circuit has an error:
Table 1
                   
    EVENT ACTIVE REPORT        
           
    HYD. OIL TEMP ERR        
           
    CALL SHOP        
           
               Pressing the "More" key will display the diagnostic information ("MID, CID, and FMI codes") for the event on the message area. An example is shown here:
Table 2
                   
    EVENT ACTIVE REPORT        
           
    HYD. OIL TEMP ERR        
           
    MID051 CID0600 FMI03        
           
               Proceed to the diagnostic code procedure with the same CID/FMI in order to troubleshoot the System event .Module Identifier (MID)
The VIDS displays maintenance events that originate from electronic controls. The events are shown on the message area. The other electronic control modules that are located on the machine transfer "diagnostic information" via the CAT data link to the VIDS ECM.The electronic control module that has detected a failure is identified by the Module Identifier (MID). Each of the electronic control modules on the machine have a unique MID. Use table 3 in order to match the MID for each failure to an electronic control module. Refer to the "Module Identifier table" on the machine's Electrical System Schematic if the MID that is shown does not appear in table 3. After the electronic control module that detected the failure has been identified, refer to the failed controls Service Manual for troubleshooting information ("CID/FMI"). The Service Manual modules for each control are part of the machine Service Manual. If the MID is for the machine ECM use this Service Manual, RENR3103 module to troubleshoot the failure. This Service Manual, RENR3103 contains troubleshooting procedures for only the machine electronic control module. Refer to the Troubleshooting section of this manual for the "CID/FMI troubleshooting procedures".
Table 3
"Module Identifier (MID) Description"    
MID No.    Description    
036     Engine Electronic Control Module    
039     Machine Electronic Control Module    
051     VIDS Electronic Control Module