AXLE AR REAR 8K6331 - Caterpillar

Illustration 1 g03868982
(1) Operator Alert Indicator
Table 1
OPERATION    
Warning Level    Warning Indications    Required Operator Action    Possible Result (1)    
Amber Action indicator Red Action Indicator    Rear Action Indicator    Action Alarm    
1     OFF     OFF     OFF     OFF     No action is required. The warning is recorded.     No harmful effects.    
2     OFF     ON     ON     OFF     Change machine operation or perform maintenance to the system.     Damage to system components.    
3     OFF     The Indicator Flashes ON and OFF.     ON     The alarm pulses ON and OFF.     Immediately perform a safe engine shutdown.     Injury to operator or severe damage to components.    
( 1 ) This is the possible result if no action is taken by the operator.Note: The warning indicator (1) has one color. The color of the indicator is red. The indicator will flash red for usual warning levels. If communication with the CAN data link is lost to the display module, the warning indicator will turn ON.The monitoring system has the following three warning levels for events:Warning Level 1 - Warning Level 1 does not affect the operation of the machine or alert the operator that a warning has occurred. Warning Level 1 is recorded and may be viewed from the "Diagnostics" menu of the display or with Cat® Electronic Technician (Cat ET) Service Tool.Level 2 - Warning Level 2 requires changing the operation of the machine or performing a maintenance procedure. Failure to correct the problem that caused this warning may result in damage to the involved components or the involved system of the machine.Level 3 - Warning Level 3 requires an immediate safe shutdown of the machine to avoid damage to the machine or injury to personnel around the machine. The problem that caused the event must be corrected before machine operation can resume.Note: Certain conditions will allow the machine to be operated in the limp home mode.Table 1 indicates the status of the alarm and "Check Monitor" indicator for each warning level. If the monitoring system detects an abnormal operating condition, the operator will be notified.