AXLE AR-REAR 8U1851 - Caterpillar

Table 1
Part Description Qty
Vacuum Transducer 1
Fitting 2
Vacuum Cap(1) 2
(1) Use one vacuum cap in order to connect to the hydraulic tank for the implements. Use the other vacuum cap in order to connect to the hydraulic tank for the steering.
Illustration 1 g00733078
Illustration 2 g00710160There are three case drain filters for the implement pumps. The filters are located in front of the cab.
Illustration 3 g00733079
Illustration 4 g00460774There are two case drain filters for the steering pumps. One filter is located on each side of the machine on the rear frame.
Stop the engine.
Use the components that are listed in table 1 in order to assemble the vacuum system.
Install the vacuum system onto the filler tube for the hydraulic oil.
Connect an air hose to the fittingand turn on the air supply.
Use a strap type wrench to remove the case drain filters. Dispose of the used filter elements properly.
Clean the filter mounting bases. Make sure that all of the used gaskets are removed from the filter mounting bases.
Lubricate the gaskets of the new filter elements with clean hydraulic oil.
Install the new filter elements by hand. After the gasket of each filter element contacts the filter mounting base, tighten each filter element by an additional 3/4 turn.
Start the engine and run the engine at low idle. Inspect the filters for leaks.