BACKHOE AR-STANDARD STICK 9R8262 - Caterpillar

1. Remove bolts (1) from shroud. 2. Disconnect shroud from tube (2) and remove shroud. 3. Loosen tensioner bolt (3) and compress tensioner cylinder and remove belt (4).
Care must be taken when removing and installing tube (7). The banjo bolt that holds tube (7) in place is hollow, with an oil hole, so it must be tightened into place carefully. Also, the tube must have a seal washer on each side of the tube.
4. Disconnect wire (5) and tube (7). Remove three bolts (6) and remove tensioner (8) with large O-ring seal. At the time of assembly, install o-ring seal (9) on the back side of the tensioner. Install in the reverse order.Disassemble And Assemble Belt Tensioner
Start By:a. remove belt tensioner 1. Remove bolt (1) and remove belt tensioner cylinder (2). 2. Remove plastic slug (3) and spring (4) from tensioner body. 3. Remove snap ring (5), washer (6) and seal (7) from tensioner body. Assemble in the reverse order.End By:a. install belt tensioner