BAFFLE GP 2784544 - Caterpillar

Table 1
Problems    Causes    Solutions    
The machine vibrates excessively during operation     Break or loss of one or several tools     Replace the damaged tools    
Too high rotational speed during the machine operation Check to ensure that the supplied oil flow corresponds to the quantity indicated on the type plate.    
Uneven worn out tools Replace all tools    
Unbalance of the rotor Contact the authorized dealer of your area or the authorized workshop    
The rotor does not turn at the right speed     Insufficient oil flow.     Check to ensure that the supplied oil flow corresponds to the quantity indicated on the type plate.    
Sliding of the drive-belts Tension the drive-belts and replace the belts, if necessary    
The machine stops or works "with beats     Sliding of the drive-belts     Tension the drive-belts and replace the belts, if necessary.    
Material gets caught: branches, stumps, cables and/or ropes made of steel or made of other material, steel wire, and the like. Lower the machine so that the rotor touches the ground. Then pull or push the machine with the tractor so that the rotor turns and remove possible foreign objects. If not sufficient, contact the dealer authorized in your area or the authorized workshop.    
The pressure relief valve mounted on the motor is activated Reduce the working speed    
Excessive usage of the tractor     Very thick material to be shredded     Reduce the speed of the tractor and open the rear door slightly. Shred the material, if necessary, by not moving the machine.    
The dimensions of the material to be crushed are too large Interrupt the work and use a more suitable machine / machine model    
Excessive quantity/height of the material to be shredded Regulate the cutting height and adjust the speed to the actual conditions.    
Material gets caught: branches, stumps, cable and/or ropes made of steel or made of other material, steel wire, and so forth. Lower the machine so that the rotor touches the ground. Then pull or push the machine with the tractor so that the rotor turns and remove possible foreign objects. If not sufficient, contact the dealer authorized in your area or the authorized workshop.    
The rotor does not turn     Worn out belts     Replace the belts    
No oil flows to the hydraulic motor Check to ensure that the tubes for the supply, outflow, and drainage to the hydraulic motor are connected correctly    
The machine does not shred, the machine does not mix evenly     Incorrect regulation     Adjust the machine in relation to the ground so that the machine touches the ground as evenly as possible    
Worn out tools Replace all tools    
Low rotational speed of the rotor Check to ensure that the supplied oil flow corresponds to the quantity indicated on the type plate.    
The adjustments of the machine are not suitable for the work to be carried out Adjust the machine