BALL JOINT AS 2430910 - Caterpillar

Supply Pump for the Work Tool
Pump Flow Control Mode (Parameter #6)Set the pump to supply oil flow to the work tool using the following parameter settings for the work tool.Note: "Pump Flow Control Mode" is only available on the 336 through 320 size machines. Drive pump flow is only available for the work tool on the 349 and 311 through 319 size machines for this system.Pump #1 - Drive PumpPump #2 - Idler PumpCombined Flow - Both Pumps
Select Pump #1 or Pump #2.
"ATT Valve #1" (Parameter #27 through #36) are now available for setting.
"ATT Valve #2" (Parameter #37 through #45) are set by parameters used for "ATT Valve #1" for one pump setting.
Pump #1 is recommended when multiple operation of work tool along with swing or stick function are frequently used.
Pump #2 is recommended when multiple operation of work tool along with bucket or boom function are frequently used.
Select Combined Flow.
(Parameter #27 through #45) are now available for setting.Pump Flow to the Work Tool (Single Operation)
One Pump Flow using the Drive or Idler Pump
Note: Drive pump flow is only available for the work tool on the 349 and 311 through 319 size machines for this system.
Set the appropriate flow for the work tool to be installed by using the following parameter settings."Atch #X Flow Setting" (Parameter # 27) - XXX [L/min]
Table 1
Maximum Flow Setting for One Pump Flow
349E / 349F 385 L/min (101.7 US gal/min)
336E / 336F 289 L/min (76.3 US gal/min)
329E / 329F / 330F 247 L/min (65.3 US gal/min)
326F 231 L/min (61.0 US gal/min)
324E 231 L/min (61.0 US gal/min)
323E / 320E / 320E