BALL BEARING 5362653 - Caterpillar

Equipment ID
As currently stated.Low Idle - Default 600 RPM, Value 600–800 RPM
Engine speed at low idle, i.e with a 0% throttle demand.Number of Synchronized Engines - Default 1, Value 1–3
This is the number of engines configured in a group for throttle synchronization.Engine Speed Control Source Transfer Maximum Speed Difference - Default 50 RPM, Value 50-200 RPM
Speed difference between primary and secondary throttle demands which must be less than this value in order for throttle synchronization to become active.Maximum Trolling Engine Speed - Default 900 RPM, Value 750-1200 RPM
Maximum allowable engine speed when trolling mode is active.Engine Location - Default Port. Value - Port, Starboard, Centre
In a situation where multiple engines communicate on one J1939 channel, the engine location parameter defines the identity of each engine in the set.Multiple Engines on J1939
Engine Location
In a situation where multiple engines communicate on one J1939 channel, the Engine Location parameter defines the identity of each engine in the set.
Table 1
Value Default
Engine #1
Engine #2
Engine #3
Engine #4
Engine #5 Engine #1 Configurable Inputs
Coolant Level Switch - Default Installed, Value Installed, Not Installed
Description as is.Fuel Level Sensor - Default Not Installed, Value Installed, Not Installed
If set to installed then the ECM will read fuel level based on the sensor input. If fuel level drops below configured level, then J1939 diagnostic 96–17 will be displayed.Exhaust Temperature Sensor- Default Not Installed, Value Installed, Not Installed
If set to installed then the ECM will read exhaust outlet temperature. If temperature exceeds configured level, then J1939 diagnostics 173–15 & 173–16 will be displayed.Seawater Output Pressure Configuration - Default Not Installed, Valued Installed, Not Installed
If set to installed then ECM will read sea water pressure at the outlet of the sea water pump. If the pressure falls outside of the configured window, then diagnostics 2435–X will be displayed.Transmission Oil Temperature Sensor - Default Not Installed, Value Installed, Not Installed
If set to installed then ECM will read transmission oil temperature. If the temperature exceeds the configured limit, then J1939 diagnostics 177-X will be displayed.Transmission Oil Pressure Sensor - Default Not Installed, Value Installed, Not Installed
If set to installed then ECM will read transmission oil temperature. If the pressure falls outside the configured windows, then J1939 diagnostics 127–X will be displayed.Fuel/Water Separator Switch Installation Status - Default Not Installed, Value Installed, Not Installed
If set to installed then switch status is monitored by the ECM. If water is detected, then the ECM will display J1939 diagnostics 97–X.Desired Speed Input Configuration - Default PWM, Value PWM, 0-5 Volts, CAN
Selects the input configuration for the Primary throttle input (Accelerator Pedal #1).Secondary Desire Speed Input Configuration - Default PWM, Value PWM, 0-5 Volts, Can
Selects the input configuration for the Secondary throttle input (Accelerator Pedal #2).System Settings
Customer Password 1
Description as is.Customer Password 2
Description as is.System Operating Voltage Configuration
Description as is.Glow Plug Start Aid Installation Status - Default Not Installed, Value Installed, Not Installed
Configures installation of the glow plugs. If installed they will activate of the cold start strategy.