BALL 6C0021 - Caterpillar

Removal Procedure
Start By:
Remove the secondary fuel filter. Refer to Disassembly and Assembly, "Fuel Filter (Secondary) and Fuel Filter Base - Remove and Install".
Remove the fuel priming pump and the primary fuel filter. Refer to Disassembly and Assembly, "Fuel Priming Pump and Primary Filter (Water Separator) - Remove and Install".Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
Illustration 1 g01178892
Disconnect hose (1) from elbow (2) .
Illustration 2 g01178893
Remove bracket assembly (3) .
Illustration 3 g01178894
Disconnect harness assembly (4) .
Remove studs (5), bolts (6), and elbow (2) .
Illustration 4 g01178896
Disconnect harness assembly (7) .
Remove bolts (8) and air inlet heater (9) .