BALL BEARING 6V3205 - Caterpillar

Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00598632
Lubricate pushrods (6) with clean engine oil. Install pushrods (6) in the cylinder head.Note: Ensure that the pushrods are installed correctly in the socket of the valve lifters.
Install caps (7) on the top of the valve stems.
Illustration 2 g00598617
Install rocker shaft assembly (4) and the base for the valve mechanism cover on cylinder head (5) .Note: Lubricate nuts (2) with clean engine oil before installation.
Install bolts (1) and nuts (2) finger tight.Note: Ensure that the ends of the adjusting screws on each rocker arm are properly seated in the ends of pushrods (6) .
Tighten bolts (1) on each end of the base for the valve mechanism cover.
The nut tightening sequence moves from the center of the rocker shaft outward. Tighten nuts (2) evenly to the following torque: 3013 Engine ... 22 N m (16 lb ft) 3014 and 3024 Engines ... 33 N m (24 lb ft)
Adjust the valve lash. Refer to the Testing and Adjusting Module, "Air Inlet and Exhaust System" topic for the correct procedure to adjust the valve lash.End By: Install the valve mechanism cover. Refer to Disassembly and Assembly, "Valve Mechanism Cover - Remove and Install".