BAND-BEAD SEAT 3969365 - Caterpillar

Note Item QTY Measure
Unit Part # Name
1
600
mm 5P-5623 Wire
2
25
mm 125-7874 Tube
3
1
2L-8081 Terminal
4
1
186-3736 Socket
5
1
234-1892 Flash file
GROUP TWO REWORKGroup Two - Procedure one: This procedure willaddress the rear steering over responsiveness that some machines may experience.1. Remove 226-5698 cartridge valve kit fromback left hand side (see photo) of 211-4172 valve bank gp.
Illustration
Place 231-1509 cartridge valve kit into port that226-5698 was removed from and tighten.
Remove hose from 148-8336 connector on front top(see Illustration) of 214-4787 valve and plug hose.
Illustration
Remove 148-8336 connector and replace it with132-1204 connector.
Reassemble hose from step 3.
Bill of material: Group 2 - Procedure 1
Note Item QTY Measure
Unit Part # Name
1
1
231-1509 cartridgevalve
2
1
132-1204 valve-check
GROUP THREE REWORK
This procedure will include installing a coverover the rear wheel drive calibration switch?s to prevent inadvertent lossof calibration by toggling switch?s in operation mode.
Remove the 3 screws on top of the console. Afterthe screws are removed, open the console panel.
Drill and tap the holes in the plate to the dimensionsthat are shown on the Illustration. (This view is looking from the topdown.) See the Illustration.
Illustration - Cover Location
Assemble cover 239-8457 over the switches withtwo 7x-3319 screws.
Bill of material Group 3
Note Item QTY Measure
Unit Part # Name
1 2 7X-3319 Screw
2 1 239-8457 Cover