BAND & LINING AS-BRAKE 8E7641 - Caterpillar

Generator Set: 3406C GEN SET (S/N: C5G1-UP) 3456 GEN SET (S/N: C3G1-UP) 3456 GEN SET (S/N: C4G1-UP) C15 GEN SET (S/N: C5E1-UP) C15 GEN SET (S/N: C5H1-UP) C18 GEN SET (S/N: STD1-UP; STM1-UP; EKW1-UP) C27 GEN SET (S/N: DWB1-UP) C9 GEN SET (S/N: C9E1-UP)Introduction
There is an improved 237-5070 Window that is now available through Caterpillar service parts. The window is now constructed from a high grade polycarbonate material.Note: When you are installing the window, a solution of soapy water is the only approved lubricant.Important Safety Information
Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs.A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools in order to perform these functions properly.Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard. Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive. If a tool, a procedure, a work method or operating technique that is not specifically recommended by Caterpillar is used, you must ensure that it is safe for you and for other people to use. You should ensure that the product will not be damaged or the product will be made unsafe by the operation, lubrication, maintenance or the repair procedures that are used.Required Parts
237-5070 Window
237-5071 Seal
237-5072 Seal
5P-1720 Seal Pick
Installation tool for the window seal insert Note: Each seal will require 200cm in order to complete the job.Note: The installation tool for the window seal insert is available as an OEM aftermarket tool. The installation tool can be purchased from the following company:Lisle Corporation
813 E. Main Street, Clarinda, IA 51632
(712) 542-5101The following is a list of tools that are needed from the Lisle Corporation:
The part number for the installation tool is 47000.
The part number for the standard tip is 47040.
The part number for the dodge tip is 47030.Installation Procedure
Note: The door of the enclosure must be removed in order to change the window on enclosures that are high off of the ground.Perform the following procedure:
In order to remove the old window and the old window seal, you must first remove the inside window seal from the inside of the door.
Illustration 1 g02005580
Start along the side or the top of the window opening. Fit the 237-5071 Seal into the window opening. Verify that the face