BAR 1226080 - Caterpillar

The "FTP Settings" page is used to configure the FTP server settings for file downloads from the health interface module to the office.Note: The information needed to configure the "FTP Settings" is available from the network administrator of the site.Perform the following procedure to configure the FTP settings on the health interface module:
Select the "COMMUNICATOR" menu and then select "FTP Settings" menu from the left panel.The "FTP Settings" page displays. Refer to Illustration 9.
Ensure that the "FTP Mode" is configured as "Passive".The "FTP Mode" should not be set to "Active" unless instructed by the IT department of the mine site.
Enter the following FTP server information in the "Office Settings" section:
IP address
Port number
User name
Password
Path for location of where the files will be sent
Click the "Apply" button to save the settings.The "FTP Settings were properly saved" confirmation message will display. These settings are critical for pushing files to an FTP server.GPS Configuration
The "GPS" menu is provided to configure specific GPS settings. The following menus are accessed from the "GPS" menu to complete the GPS configuration:
"Corrections Configuration"
"Geo Transform File Upload" or "APP File Upload"
Configuration with Terrain for grading and loadingNote: The health interface module automatically detects the satellite receiver connection."Corrections Configuration"
Illustration 10 g03226497
"Corrections Configuration" pageThe "GPS Corrections Configuration" page is provided to enter the UDP port value that is configured for the base station. This value is the port number that the health interface module listens on for GPS corrections.Note: The IP address of the health interface module must be registered with the base station to be able to receive GPS corrections.Perform the following procedure to configure the UDP Port settings:
Enter the port number in the "UDP Port" field. The value must be the same that is configured for the base station.Note: The default value for the "UDP Port" is 3784.
Press the "Apply" button.The "UDP Port Number Was Saved successfully" will display.
Once the health interface module receives GPS corrections, the "Correction Type" field displays the type of GPS corrections that is received from the base station.The following type of GPS correction values may display:
"CMR"
"CMR+"
"CMRx"
"RTCM V3"
"Unknown""Geo Transform File Upload"
The "Geo Transform File Upload" configuration is only applicable to health interface modules that are connected to an SK8 low precision satellite receiver.A geographic transformation file is required to get local coordinates to interpret GNSS positions that are received from the attached satellite receiver.Refer to Special Instruction, REHS7306, "Guide for Creating a Geo Transform File" for information on how to create a geo transform file.
Illustration 11 g03228136
"Geo Transform File Upload" pageThe "Geo Transform File Upload" page is provided to upload a geo transform file for an SK8 low precision satellite receiver.Perform the following procedure to upload a geo transform file:
Select the "Browse..." button and browse to the location of the geo transform file.
Select "Upload File" button to load the selected file to the ECM.
Once the file is uploaded, the file is validated to ensure compliance with the expected geo transform file format.An invalid file format will be rejected. If the file is invalid, then the "File