BAR (R.H.) 1V6355 - Caterpillar

Do not operate or work on this machine or work tool unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals and Owner's Manuals. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your Caterpillar dealer for replacement manuals. Proper care is your responsibility.
Diesel engine exhaust contains products of combustion which may cause personal injury.Always start and operate the engine in a well ventilated area, and, if in an enclosed area, vent the exhaust to the outside.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Personal injury or death can result from improperly checking for a leak.Always use a board or cardboard when checking for a leak. Escaping air or fluid under pressure, even a pin-hole size leak, can penetrate body tissue causing serious injury, and possible death.If fluid is injected into your skin, it must be treated immediately by a doctor familiar with this type of injury.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations and mandates.
A visual inspection of the propulsion system and the components that are part of this system is the first step during the diagnosis of a problem. Stop the engine, and make the following inspections.
Measure the oil level in the hydraulic oil tank.
Use a clear container to obtain an oil sample from the hydraulic tank immediately after the engine is stopped. Examine the sample for air bubbles.
Check all oil lines and check all connections for damage. Look for oil on the ground under the machine.
Remove the hydraulic oil filter and examine the filter element for debris.
Shiny steel particles indicate a pump failure or shiny steel particles could indicate deterioration of the internal components of the pump. Shiny steel particles can also indicate failure of the motor or shiny steel particles could indicate deterioration of the internal components of the motor.
Rubber particles indicate seal failures or hose failures.
Bronze colored particles indicate pump port plate failure.
Aluminum particles indicate a pump group failure.Note: When foreign particles are found, all hydraulic systems on the machine must be thoroughly flushed. Each hydraulic system must be filtered independently. Do not reuse damaged parts.
Inspect the control