BAR AS 2794357 - Caterpillar

Illustration 4 g00626017
Use Tooling (D) to position pin (16) and the cap assembly into rear axle housing (4). The weight of pin (16) is approximately 75 kg (166 lb).
Install ring (17) onto pin (16).
Illustration 5 g00626013
Illustration 6 g00626015Note: Lubricate the pin bore of bearing caps (15) with Tooling (G).
Install bearing cap (15) onto pin (16), as shown.
Illustration 7 g00517051
Illustration 8 g02200395
Use Tooling (A) to lower the frame assembly and raise rear axle housing (4) by approximately 75 mm (3 inch) to connect rear axle housing (4) to the frame assembly.
Illustration 9 g02200293
Apply Tooling (G) to the washers and the threads of bolts (14).
Use Tooling (B) to install bolts (14) and connect bearing cap (15) to the frame assembly. Tighten bolts (14) to a torque of 475 50 N m (350 37 lb ft). After bolts (14) have been tightened, turn bolts (14) by an extra 60 5 degrees.Note: Tooling (B) must be modified to install the bolts that are closest to the frame assembly. Remove the top 20 mm (0.8 inch) from Tooling (B).
Repeat Steps 10 for the remaining bearing cap.
Illustration 10 g00626029
Install plate (13). Install three of bolts (12), equally spaced. Tighten bolts (12) to a torque of 200 25 N m (148 18 lb ft). Use Tooling (F) to measure the distance between the pin and the outside surface of plate (13).
Remove bolts (12) and plate (13).
Measure the thickness of plate (13) and subtract this value from the value that was obtained in Step 12.
Illustration 11 g00625951
Install a number of shims that equals the value that was obtained in Step 16 plus 0.25 mm (0.01 inch). Install plate (13). Install bolts (12). Tighten bolts (12) to a torque of 750 90 N m (555 66 lb ft)
Illustration 12 g00627913
Use a suitable lifting device to position drive shaft (11). Install new bolts (10). Tighten bolts (10) to a torque of 550 20 N m (406 15 lb ft).
Illustration 13 g00625955
Position plate (9) and install bolts (8).
Illustration 14 g00625945
Position hose assembly (5) and hose assembly (6). Install bolt (7).
Illustration 15 g00625948
Connect hose assembly (5) to rear axle housing (4).
Illustration 16 g00625943
Position hose assembly (2) and install bolt (3).
Illustration 17 g00625941
Connect hose assembly (2) to magnetic screen (1).
Refill the transmission tank with hydraulic oil. Refer to Operation and Maintenance Procedure, "Transmission Tank Oil - Change".End By:
Install the hoist control valve. Refer to Disassembly and Assembly, "Control Valve (Hoist) - Remove".
Remove the wheel chocks. Refer to Disassembly and Assembly, "Wheel Chock (Front and Rear) - Remove and Install".