BAR GP-EQUALIZER 3462865 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     Ft-1114     Vacuum Cap     1    
5P-0306 Vacuum Transducer     1    
6V-4142 Fitting     1    
5k-5068 Fitting     1    
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release".
Illustration 1 g01101807
Remove the hydraulic tank cap and install Tooling (A). Apply 276 kPa (40 psi) to 414 kPa (60 psi) of air pressure to Tooling (A) .
Illustration 2 g01108407
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Remove hydraulic oil cooler bypass valve (1) and the O-ring seal.Installation Procedure
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
A     Ft-1114     Vacuum Cap     1    
5P-0306 Vacuum Transducer     1    
6V-4142 Fitting     1    
5k-5068 Fitting     1    
Illustration 3 g01108407
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install the O-ring seal and hydraulic oil cooler bypass valve (1) .
Illustration 4 g01101807
Release the air pressure from Tooling (A). Remove Tooling (A) from the hydraulic tank and replace the hydraulic tank cap.
Check the fluid level in the hydraulic tank. Add hydraulic fluid, if necessary. Refer to Operation and Maintenance Manual, "Hydraulic Tank Oil - Change" for the correct filling procedure.