BAR AS-EQUALIZER 3473571 - Caterpillar

Table 36
Commissioning Specifications    
Description    Specification    Actual    Comments    
Engine Low Idle Speed     710 20 rpm     :     :    
Engine High Idle Speed     2300 50 rpm     :     :    
Brake Pressure (Cut in)    
7600 350 kPa (1100 50 psi)     :     :    
Cut Out Brake Pressure    
9650 350 kPa (1400 50 psi)     :     :    
Standby Brake Pressure    
900 kPa (130 psi) at low idle     :     :    
Hydraulic Signal Relief Pressure    
22400 700 kPa (3250 100 psi)     :     :    
Hydraulic Pressure (Pump)    
24100 1050 kPa (3500 150 psi)     :     :    
Hydraulic Pressure (Standby)    
2750 850 kPa (400 120 psi)     :     :    
Hydraulic Steering Relief Pressure    
24100 690 kPa (3500 100 psi)     :     :    
Transmission Pressure    
34 to 207 kPa (5 to 30 psi)     :     :    
Differential Pressure    
2700 1025 kPa (390 150 psi)     :     :    
Transmission Pump Pressure (High Idle)    
2650 525 kPa (385 75 psi)     :     :    
Table 37
Implement Cycle Times    
Implement     The Cycle of the Cylinder
The Rotation of the Circle
The Number of Turns of the Steering Wheel     Implement Cycle Times in Seconds     Actual Implement Cycle Times in Seconds     Comments    
Blade Lift     Rod In (1)
Rod Out (1)     2.4 0.2
2.4 0.2            
Centershift     Rod In
Rod Out     10.5 1.0
10.3 1.0            
Wheel Lean     Rod In
Rod Out     2.3 0.2
3.1 0.3            
Blade Tip     Rod In
Rod Out     4.9 0.5
4.6 0.5            
Sideshift     Rod In
Rod Out     15.0 1.5
16.7 1.7            
Ripper     Rod In (1)
Rod Out (1)     3.0 0.3
4.0 0.4            
Articulation     Stop to Stop     8.5 0.9            
Circle Rotation     1/4 Revolution     14.5 1.5            
Steering Wheel     Number of Turns     7 0.7            
( 1 ) Place two marks on the cylinder rod 305 mm (12 inches) from each other. This is called running distance.Note: Refer to Service Manual, SENR8695 for the appropriate checking procedures.Note: The cycle times for the implements should be performed at high idle with the hydraulic oil at the operating temperature.