BAR STOP ANGLE 5P0976 - Caterpillar

40. Install three friction discs (83) and two clutch plates (84) in alternating order, starting with a friction disc (83) and ending with a friction disc (83). 41. Install 12 springs (85) in clutch housing (69). 42. Install two seal rings (86) and (87) in clutch piston (88). 43. Position clutch housing assembly (89) as shown. Install the dowels. 44. Install clutch piston (88) in clutch housing (89). 45. Attach Tooling (B) to clutch housing (89). Turn clutch housing (89) over. Using two 1/2-13 NC forged eyebolts and a suitable lifting device install clutch housing (89). The weight of clutch housing (89) is 34 kg (75 lb). 46. Using Tooling (F), and a suitable lifting device, install ring gear (90). 47. Install five friction discs (91) and four clutch plates (92) in alternating order, starting with a friction disc (91) and ending with a friction disc (91). Using Tooling (E), install retaining ring (93). 48. Install three friction discs (94) and two clutch plates (95) in alternating order, starting with a friction disc (94) and ending with a friction disc (94). 49. Install 12 springs (96) and six dowels (97). 50. Install two seals (98) and (99) on clutch piston (100). 51. Install clutch piston (100) in clutch housing (101). 52. Attach Tooling (B) to clutch housing (101). Turn clutch housing (101) over. Using two 1/2-13 NC forged eyebolts and a suitable lifting device, install clutch housing (101). Install two bolts (102) and the washers. The weight of clutch housing (101) is 34 kg (75 lb). 53. Install carrier ring (103), dowel (104), and two ring seals (105) and (106) on clutch housing (107). 54. Install ring seal (108) and (109) on clutch piston (110). 55. Install clutch piston (110) on clutch housing (107). 56. Install three spring plates (111) and one retaining plate (112) on clutch housing assembly (107). 57. Put clutch housing assembly (107) in position n a suitable press. Using Tooling (G), compress retaining plate (112) and install retaining ring (113). 58. Using two 1/2-13 NC forged eyebolts and a suitable lifting device, install clutch housing assembly (107). Use caution when lifting and turning clutch housing assembly (107) over so clutch piston (110) does not fall out. Install 20 bolts (114) and washers. Install two bolts (115) and the washers. The weight of clutch housing assembly (107) is 23 kg (50 lb). 59. Apply 4C-4030 Thread Lock Compound to the threads of setscrew (116) and install it in clutch housing (107). Tighten each setscrew in half turn intervals until setscrew (116) touch clutch piston (110). Once clutch piston (110) is completely compressed, alternately loosen each setscrew (116), three and a quarter turns, 1/8 of a turn. 60. Tighten each jam nut (117) to a torque of 12 3 N m (106.2 26.6 lb in). 61. Install three dowels (118) and (122), O-ring plug (119), and two O-ring seals (120) and (121) in manifold assembly (123). 62. Install fitting (126), O-ring seal (125),