BAR 5V0458 - Caterpillar

Illustration 1 g01937473
Top view (1) Sleeve bearing Inside diameter ... 127.50 mm (5.020 inch) Outside diameter ... 140.20 0.08 mm (5.520 0.003 inch) (2) Apply 1U-8846 Liquid Gasket to the mating surfaces before assembly. (3) Torque for four bolts ... 570 80 N m (420 59 lb ft) (4) Torque for 48 bolts ... 300 40 N m (221 30 lb ft) (5) Torque for the oil level gauge assembly ... 45 6 N m (33 4 lb ft) (7) The rubber toric seals and all the contacting surfaces must be clean and dry at assembly. Prior to assembly, apply a thin layer of oil to the contacting surfaces of the metal seal rings. The seal rings must be assembled square with the bore. The rubber toric seal should not bulge and the rubber toric seal should not twist. Refer to Special Instruction, SEHS8364, "Assembly and Installation of Conventional Duo-Cone Seals". (7) Torque for the pipe plug ... 45 6 N m (33 4 lb ft) (8) Sleeve bearing Inside diameter ... 175.23 mm (6.899 inch) Outside diameter ... 187.81 0.08 mm (7.394 0.003 inch)
Illustration 2 g01937518
Right side view (9) Torque for 30 bolts ... 300 40 N m (221 30 lb ft) (10) Torque for the O-ring plug ... 210 20 N m (155 15 lb ft) (11) Torque for the magnetic plug ... 210 20 N m (155 15 lb ft)
Illustration 3 g01937519
(12) Torque for two purge screws ... 11 4 N m (97 35 lb in) (13) Torque for the pressure relief fitting ... 13 4 N m (115 35 lb in) (14) Torque for two O-ring plugs ... 210 20 N m (155 15 lb ft)