parts catalog

BAR 5V3874 - Caterpillar

5V3874 BAR Caterpillar parts 980C BAR
Alternative (cross code) number:
Caterpillar 5V3874 BAR
Weight: 1 pounds 0 kg.

Buy BAR 5V3874 Caterpillar genuine, new aftermarket tractor parts with delivery

Compatible equipment models: 5V3874:

WHEEL LOADER  980C   Caterpillar
Number on catalog scheme: 18
  For full view, you need register


Personal injury or death can result from a fire.Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire.Clean up all leaked or spilled fuel. Do not smoke while working on the fuel system.Turn the disconnect switch OFF or disconnect the battery when changing fuel filters.
Do not pre-fill the fuel filter with fuel before you install the fuel filter. Contaminated fuel WILL DAMAGE the fuel system components.
Caterpillar STRONGLY recommends the use of ultra-high efficiency secondary fuel filters for this machine model. Ultra-high efficiency fuel filters are designed in order to better protect diesel engines that have higher injection pressures and closer tolerances. Use of secondary fuel filters that are NOT ultra-high efficiency fuel filters will result in shortened fuel system component life. Caterpillar ultra-high efficiency fuel filters are the preferred secondary filters for this machine model.
Severe working conditions can shorten the life of the fuel system. Severe conditions refer to a dusty environment and/or dirty fuel. Under severe conditions, reduce the maintenance interval to 250 service hours.
In order to keep the engine in optimum condition, it is important to keep the fuel free from contamination. As fuel system contamination usually occurs during refueling, the following points should be observed:
Only use clean fuel of the correct grade from a reliable source.
Do not refuel from contaminated containers or containers that are not suitable for fuel storage.
Do not use contaminated equipment.
Regularly clean the outside of the fuel filler cap and the area around the fuel filler cap.
Only use Caterpillar approved fuel filters. The use of Caterpillar filters is essential in order to protect the fuel system.
Do not service the fuel filters ahead of the suggested maintenance interval, unless you are instructed by the monitoring system. Changing the fuel filters ahead of the suggested maintenance interval will increase the risk of contamination in the fuel system.Note: In order to reduce the risk of contamination in the system, do not remove the primary fuel filter and the secondary fuel filter simultaneously. Perform these operations separately.Note: After the engine has stopped, you must wait for 60 seconds in order to allow the fuel pressure to be purged from the high-pressure fuel lines before any service or repair is performed on the engine fuel lines.
Illustration 1 g03021259
Open the left side engine compartment. The secondary fuel filter is located on the left side of the machine toward the rear of the engine compartment.
Ensure that the fuel supply valve (if equipped) is in the OFF position. Place a suitable container under the fuel filter in order to catch any fuel that might spill. Clean up any spilled fuel.
Clean the outside of the fuel filter. Use a Caterpillar strap wrench in order to remove the filter from the engine and dispose of

Caterpillar parts catalog:

Caterpillar parts catalog

Parts bar Caterpillar catalog:

6W4596 BAR-RH
950B, 950B/950E
6W4597 BAR-LH
950B, 950B/950E
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.