BAR (R.H.) 7V1485 - Caterpillar

Illustration 1 g02529802
Top view
Table 1
Specification for 353-2586 Screed Plate Gp    
Item     Qty     Part     Specification Description    
-     -     As required, use the following shims.    
1     3     8I-0888 Shim     Thickness is
0.254 mm (0.0100 inch).    
2     3     8I-0890 Shim     Thickness is
1.626 mm (0.0640 inch).    
3     6     8I-0889 Shim     Thickness is
0.508 mm (0.0200 inch).    
4     1     352-6133 Heater As     Before you install the heater assemblies on the screed plates, apply
10 mm (0.4 inch) wide and
5 mm (0.2 inch) thick bead of 257-8023 Thermal Grease to bottom of the heater assemblies.    
5     1     353-1639 Heater As    
Illustration 2 g02529801
Section A-A
Table 2
Specification for 353-2586 Screed Plate Gp    
Item     Qty     Part     Specification Description    
6     7     8I-0189 Stud     Apply Loctite 272 to the threads of the studs.    
7     12     290-4724 Stud     Apply Loctite 272 to the threads of the studs.    
8     12     290-4723 Adjustment Nut     Before assembly, coat the threads of the adjustment nuts with black 4C-5599 Anti-Seize Compound.    
9     8     5C-6565 Bolt     Apply Loctite 272 to the threads of the Bolts.    
10     6     6V-8188 Nut     Torque to
70 12 N m (52 9 lb ft).    
11     -     -     Back edge of the frame should not extend past back edge of the screed plate.    
B     -     -     Gap between screed plate and the nose bar is
0.0 to 1.5 mm (0.00 to 0.06 inch).    
C     -     -     Set the nose bar to be
0.0 to 0.8 mm (0.00 to 0.03 inch) below the screed plate.    
D     -     -     The gap between the deflector and the screed plate is
12.8 1.5 mm (0.50 0.06 inch).