BAR GP-BREAKER 7X9610 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     185-3630     Strap Wrench Assembly     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00813127
Use Tool (A) to remove fuel filter (3) from fuel filter base (2) .Note: It is not necessary to remove the fuel filter in order to remove the fuel filter base.
Remove banjo bolts (1) and copper washers in order to disconnect the fuel lines (4) from the fuel filter base (2). Note: Cap all openings or plug all openings immediately in order to prevent contamination of the fuel system.
Illustration 2 g00813147
Remove two bolts (5) and the washers that secure the fuel filter base (2) to the air inlet manifold. Remove the fuel filter base (2) from the fuel filter bracket.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 3 g00813147
Place the fuel filter base (2) in position on the fuel filter bracket. Install the washers and two bolts (5) that secure the fuel filter base tothe fuel filter bracket.
Illustration 4 g00813127
Install the banjo bolts (1) and install new copper washers in order to connect the fuel lines (4) to the fuel filter base (2) .
If the fuel filter was removed, install the fuel filter (3) to the fuel filter base (2). Tighten the fuel filter by hand according to the instructions that are shown on the fuel filter. Do not overtighten the fuel filter.