BAR AS 8G0802 - Caterpillar

1. Disconnect wires (4) from switch (3).2. Remove bolts (1), (2) and (5) that hold the bucket positioner on the right tilt cylinder. 3. Remove the bucket positioner as a unit. Remove rod assembly (7) from tube assembly (6).4. Remove bolt (8) and remove switch (3) from tube assembly (6). The bucket kickout location is the right side lift arm tower. 5. Remove clamp (12) and magnetic switch (11) from the right lift arm.6. Disconnect wires (9)) and remove switch (10). The following steps are for installation. For the correct adjustment of the bucket positioner and kickout, see TESTING AND ADJUSTING.7. Install switch (10) and connect wires (9).8. Install magnetic switch (11) and clamp (12) on the right lift arm.9. Put switch (3) in position on tube assembly (6) and install bolt (8).10. Slide rod assembly (7) into tube assembly (6).11. Put the bucket positioner in place on the right tilt cylinder. Install bolts (1), (2) and (5).12. Connect wires (4).