BARREL AS 1020742 - Caterpillar

Table 1
Required Tools    
Part Number    Description    Qty    
6V-9833     Cap As     1    
    Container for measuring     1    
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: The fan motor speed must be set to the correct specification before performing this test. Refer to Testing and Adjusting, "Fan Motor Speed (Hydraulic Oil Cooler) - Test and Adjust".
Position the machine on level ground.
Stop the engine.
Release the pressure in the hydraulic system. Refer to Testing and Adjusting, "Hydraulic System Pressure - Release".
Illustration 1 g01132502
(1) Fan motor (2) Case drain hose
Illustration 2 g01132503
(2) Case drain hose (3) Case drain filter
Disconnect case drain hose (2) from case drain filter (3) . Install 6V-9833 Cap As on the open fitting of case drain filter (3) .
Place the end of drain hose (2) into the container in order to measure the case drain oil.
Start the engine.
Place the machine controls at the following settings: AEC switch OFF and engine speed dial "10".ReferenceRefer to Testing and Adjusting, "Engine Performance - Test (Engine Speed)" for engine rpm settings.
Measure the amount of case drain oil for one minute.
Table 2
Case Drain Oil    
Fan Speed    Amount of Case Drain Oil    
1000 rpm (1)     2 L/min (0.5 US gpm)    
1050 rpm (2)    
2 L/min (0.5 US gpm)    
( 1 ) Standard specification
( 2 ) High ambient specification