BARREL-CYLINDER 9J5540 - Caterpillar

9J5540 BARREL-CYLINDER Caterpillar parts 227

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA9J5540
9J-5540
9J5540

Buy BARREL-CYLINDER 9J5540 Caterpillar genuine, new aftermarket tractor parts with delivery
LOGGER,

Compatible equipment models: 9J5540:

LOGGER 227 Caterpillar

Number on catalog scheme: None

Caterpillar 9J5540 Parts scheme BARREL-CYLINDER

For full view, you need register

Information:

Illustration 1 g00611752
The crankcase drain valve is located under the rear of the upper structure.
Remove the bolts and the washers. Open the crankcase drain valve access cover.
Illustration 2 g00115423
Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information that pertains to containing fluid spillage.
Open the crankcase drain valve. Allow the oil to drain into a suitable container.Note: Dispose of drained fluids according to local regulations.
Close the drain valve.
Illustration 3 g00611344
Illustration 4 g00115425
Open the access door on the right side of the machine.
Remove the oil filter with a strap type wrench. See Operation and Maintenance Manual, "Oil Filter - Inspect".Note: Dispose of the used oil filter according to local regulations.
Clean the filter housing base. Make sure that all of the old filter gasket is removed.
Illustration 5 g00101634
Apply a thin coat of engine oil to the gasket of the new filter.
Install the new filter by hand. When the gasket contacts the filter base, turn the filter by 270 degrees more. This will tighten the filter sufficiently.Every new oil filter has rotation index marks that are spaced at 90 degree increments. Use the rotation index marks as a guide for tightening the oil filter.
Close the access door on the left side of the machine.
Close the crankcase drain valve access cover.
Install the bolts and the washers.
Illustration 6 g00744114
Unlatch the engine hood and raise the engine hood.
Illustration 7 g00115426
Remove oil filler plug (2). Fill the crankcase with new oil. See Operation and Maintenance Manual, "Refill Capacities". Clean the oil filler plug and install the oil filler plug.
Do not under fill or overfill engine crankcase with oil. Either condition can cause engine damage.
Start the engine and allow the oil to warm. Check the engine for leaks. Stop the engine.
Illustration 8 g00115428
Wait for fifteen minutes so that the oil can drain back into the crankcase, before you check the oil.
Check the dipstick. Maintain the oil between the marks on the "ENGINE STOPPED" side of the dipstick.
Close the engine hood and latch the engine hood.