BARREL 9T7757 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A(1) 9U-6198 Crankshaft Turning Tool 1
B 194-3542 5mm Allen Socket 1
(1) The Crankshaft Turning Tool is used on the front pulley.Start By:
Remove the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Remove" for the correct procedure.
Remove the crankshaft rear seal. Refer to Disassembly and Assembly, "Crankshaft Rear Seal - Remove" for the correct procedure.
This procedure must only be used to remove and install the main bearing shells with the crankshaft in position.The removal procedure and the installation procedure must be completed for each pair of main bearing shells before the next pair of main bearing shells are removed.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g02441836
Use Tooling (B) in order to remove allen head bolts (1). Remove bridge piece (2).
Ensure that the main bearing cap is marked for the correct location and orientation.
Illustration 2 g02447416
Remove bolts (3) and main bearing cap (4) from the cylinder block.
Illustration 3 g02447418
Remove lower main bearing shell (5) from main bearing cap (4). Keep the main bearing shell and the main bearing cap together. Take care not to displace dowels (6). Note: The lower main bearing shell is a plain bearing that has no oil holes.
Illustration 4 g03653548
For number No. 3 main bearing, remove two thrust washers (7) from the cylinder block. In order to remove thrust washers (7), use Tooling (A) to rotate the crankshaft in the correct direction. If necessary, push the crankshaft toward the front of the engine or push the crankshaft toward the rear of the engine while you rotate the crankshaft, in order to aid removal. Note: The thrust washers have a locating tab at one end.
Illustration 5 g03653549
Push out upper main bearing shell (8) with a suitable tool from the side opposite the locating tab. Carefully rotate the crankshaft while you push on the bearing shell. Remove upper main bearing shell (8) from the cylinder block. Keep the bearing shells together. Note: The upper main bearing shell has a groove and two oil holes.Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
B 194-3542 5mm Allen Socket 1
C 8T-5096 Dial Indicator 1
- Magnetic Base and Stand 1
D - Straight Edge 1
E 165-2601 Silicon Sealant 1
This procedure must only be used to remove and install the main bearing shells with the crankshaft in position.The removal procedure and the installation procedure must be completed for each pair of main bearing shells before the next pair of main bearing shells are removed.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Ensure that the main bearing shells are clean and free from wear and damage. If necessary, replace the main bearing shells.
Clean the journals of the crankshaft. Inspect the journals of the crankshaft for damage. If necessary, replace the crankshaft or recondition the crankshaft.
Illustration 6 g03653549
Lubricate the crankshaft journal and upper main bearing shell (8) with clean engine oil. Slide upper main bearing