BASE GP-OIL FILTER 1555005 - Caterpillar

face="Courier New">Description
*******Group 1*******
1 0977404 TUBE-HEAT (Bulk - 100 mm per repair)
1 3145153 HARNESS AS
In Order to allow equitable parts availability to all participating dealers, please limit your initial parts order to not exceed 9% of dealership population. This is an inital order recommendation only, and the ultimate responsibility for ordering the total number of parts needed to satisfy the program lies with the dealer.
*******Group 2*******
1 0977404 TUBE-HEAT (Bulk - 100 mm per repair)
In Order to allow equitable parts availability to all participating dealers, please limit your initial parts order to not exceed 9% of dealership population. This is an inital order recommendation only, and the ultimate responsibility for ordering the total number of parts needed to satisfy the program lies with the dealer.
ACTION REQUIRED
Group 1
Check the prelube connector on the right hand rail harness for pins in Holes 1 and 2. If there are no pins in Holes 1 and 2, install Harness 314-5153 between the prelube harness and the rail harness. (Image1)
Check for continuity between the ring terminals and pins 5 and 6 at the connector on the 284-3039 Air Prelube Harness. If the ring terminals are not connected to pins 5 and 6 in the connector, remove the heat shrink from the connector and conduit.
Remove pins 1, 2, 5, and 6. Place a new piece of heat shrink tubing (097-7404) over the conduit.
Install the original pins 5 and 6 in holes 1 and 2, and install the original pins 1 and 2 in holes 5 and 6.
Finish by positioning the heat shrink tubing over the connector and the conduit, then heating the heat shrink tubing until it is properly attached.
Group 2
Check for continuity between the ring terminals and pins 5 and 6 at the connector on the 284-3039 Air Prelube Harness. If the ring terminals are not connected to pins 5 and 6 in the connector, remove the heat shrink from the connector and conduit.
Remove pins 1, 2, 5, and 6. Place a new piece of heat shrink tubing (097-7404) over the conduit.
Install the original pins 5 and 6 in holes 1 and 2, and install the orginal pins 1 and 2 in holes 5 and 6.
Finish by positioning the heat shrink tubing over the connector and the conduit and heating the heat shrink tubing until it is properly attached.
Image1
SERVICE CLAIM ALLOWANCES
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
*******Group 1*******
0-500 hrs 100.0% 100.0% 0.0% 0.0% 0.0% 0.0%
This is a 1.0-hour job for Group 1
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
*******Group 2*******
0-500 hrs 100.0% 100.0% 0.0% 0.0% 0.0% 0.0%
This is a 0.5-hour job for Group 2
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.