BASE 1726351 - Caterpillar

80 CC (4.9 cu in/rev) Steering Motor
Illustration 1 g01080465
(1) Apply 9S-3263 Thread Lock to the threads of the nut. Tighten the nut in order to obtain the following running torque. ... 0.75 to 1.10 N m (6.63 to 9.74 lb in)This torque provides the correct bearing preload for new bearings. Use 50 percent of the specified torque for used bearings.Note: New bearings must have the lubricant that was applied by the manufacturer. (2) Shim thickness. 9T-2581 Shim ... 0.10 mm (0.004 inch) 9T-2582 Shim ... 0.30 mm (0.012 inch)Note: As required, use shims (2) in order to attain Dimension (B) . (3) Apply 9S-3263 Thread Lock to the threads of the seven screws. The seven screws hold the retaining plate to the shaft. The seven screws are not shown. Tighten the screws to the following torque. ... 15.5 1.5 N m (11 1.1 lb ft) (4) As shown, install the belleville springs. (5) Spacer thickness 9T-2013 Spacer ... 9.55 mm (0.376 inch) 9T-2012 Spacer ... 9.65 mm (0.380 inch) 9T-2008 Spacer ... 9.75 mm (0.384 inch)