BASE AS-FILTER 2860014 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact the skin.
Drain the oil from the engine oil pan into a suitable container for storage or disposal.
Illustration 1 g00516605
Remove bolts (2) and remove sound suppression panel (1), if equipped.
Illustration 2 g00516607
Remove bolts (3) that fasten engine oil pan (4) to the cylinder block.
Remove engine oil pan (4) .
Some engines are equipped with a plate between the engine oil pan and the cylinder block. Remove the bolts and the plate from the cylinder block. Remove the plate gasket. The weight of the plate is approximately 24 kg (53 lb).Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     8T-9022     Silicone Gasket     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Apply Tooling (A) on the sealing surface of the engine oil pan and on the connecting joints of the front plate, oil pan gasket, cylinder block, and the flywheel housing. Install a new gasket on the engine oil pan.
Position a new gasket on the cylinder block and install the plate, if equipped. The weight of the plate is approximately 24 kg (53 lb).
Illustration 3 g00516607
Position engine oil pan (4) and install bolts (3). Tighten bolts (3) to a torque of 55 10 N m (41 7 lb ft).
Tighten the drain plug to a torque of 70 15 N m (52 11 lb ft).
Illustration 4 g00516605
If the engine is equipped with a sound suppression panel, position sound suppression panel (1) and install bolts (2) .
Fill the engine to the correct level with oil. Refer to Operation and Maintenance Manual, "Refill Capacities".