BASE AS- 2996216 - Caterpillar

Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.Problem
A change made to this area of frame from previous series machine and not validated specifically for this potential failure.Solution
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.
Ensure that the height of the new stop is 56.9 mm (2.2 inch) - 59.6 mm (2.3 inch) from the surface. Incorrect height of the steel steering stops causes failures of the non-metallic steering stops or damage to the snubber components of the steering cylinders. Replace with 505-5532 Plate if needed.