BASE 2D2568 - Caterpillar

Illustration 1 g02903376
Left side view
Table 1
Specification for 359-0940 Crankshaft Gp
Item Qty Part Specification Description
1 11 286-5801 Main Bearing Before assembling the crankshaft into the cylinder block, lubricate the main bearing journals with clean engine oil.
2 2 341-4708 Thrust Plate Before assembly, lubricate the new thrust plates with clean engine oil.
The new thrust plates should be used only on the rear main bearing.
3 42 237-8306 Bolt As Use the following procedure to tighten the bolt assemblies:
1. Lubricate the threads of the bolts, shank, the contact surface under the bolt head and the washer with 6V-4876 Lubricant.
2. Tighten to 220 20 N m (162 15 lb ft).
3. Again, rotate each bolt to an extra angle of 90 5 degrees.
Do not reuse the counterweight bolts. Tighten the counterweight bolts evenly.
- - - End play for a new crankshaft is 0.17 to 0.63 mm (0.007 to 0.025 inch).
- - - Maximum crankshaft deflection is 0.03 mm (0.001 inch).
Illustration 2 g02903377
Front view
Table 2
Item Qty Part Specification Description
4 10 2W-2288 Plug Tighten to 50 7 N m (37 5 lb ft).