BASE GP-FUEL FILTER 3885388 - Caterpillar

Illustration 6 g01389788
Note: The above screen should be displayed if the password that was entered is not correct.
Illustration 7 g01389783
In the service mode, use the appropriate up key (1) or down key (6) to scroll through the listed menu options. Highlight the "STATUS" setting. Press the OK key (8) .
Illustration 8 g01389785
Typical example of a display
The third line in the above illustration indicates the "STATUS" ID. Each respective ID is classified in either the "display only" or the setting for the ID. In order to change the ID, use the keys for direction. Change the "STATUS" ID to "2" for drive pump delivery pressure or "3" for idler pump pressure. After the ID has been changed, press the OK key (8) .
Illustration 9 g01344314
Position of the machine for the measurement of the pump pressure (G) Extension of boom cylinder (H) Track at the rear or the machine (J) Free space between the track and the ground
Slowly extend the boom cylinders. Extend the boom cylinders until the track that is under the rear side of the machine is above the ground. Refer to Illustration 9.
Record the measured pump pressure from the display on the monitor in the cab in Table 1.
Slowly retract the boom cylinder. Retract the boom cylinder until the track that is under the rear side of the machine is on the ground.
The value of the threshold pressure for the overload warning device is 70% of the recorded pump pressure from Step 12. This calculation is shown in Table 1.
Table 1
Calculation for Overload Warning Device (OLWD)    
Pump Pressure (PP)        
OLWD Pressure = PP x 0.7        Input The Value Of The Threshold Pressure For The Overload Warning Device
Illustration 10 g01389656
(1) Up key (2) Right key (3) Home key (4) Main menu key (5) Left key (6) Down key (7) Cancel key (8) OK key
In order to access the "OVERLOAD " parameter, you must first enter the "SERVICE" mode on the monitor.
Use the following procedure to access the "SERVICE" screen on the monitor.
Illustration 11 g01389843
Use the appropriate up key (1) or down key (6) to scroll through the listed menu options. Highlight the "SERVICE OPTIONS" setting. Press the OK key (8) .
Illustration 12 g01389860
When "PASSWORD" screen appears, use the arrow keys for direction to input the password. When the desired character is highlighted, press the OK key (8). Enter the password for service FFF2 in order to continue to the "SERVICE" screen. After the password has been entered the "SERVICE" screen should appear.
Illustration 13 g01389788
Note: The above screen should be displayed if the password that was entered is not correct.
Illustration 14 g01389883
In the service mode, use the appropriate up key (1) or down key (6) to scroll through the listed menu options. Highlight the "CONFIGURATION" setting. Press the OK key (8) .
Illustration 15 g01389884
The third line in the above illustration indicates