BASE GP-FUEL TANK 3928565 - Caterpillar

Removal Procedure
Start By:
Remove the engine oil filter base. Refer to Disassembly and Assembly, "Engine Oil Filter Base - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Inspect the O-ring seals. Replace the O-ring seals that are worn or damaged.
Illustration 1 g01329189
Remove tube assembly (1) .
Illustration 2 g01329200
Disconnect hose (2). Remove bracket (3) .
Illustration 3 g01329224
Remove bolts (4). Remove engine oil cooler (5) .
Illustration 4 g01329774
Remove O-ring seal (6). Disconnect hose (7). Remove bonnet (8) .
Illustration 5 g01329778
Remove O-ring seal (9) .Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 6 g01329778
Install O-ring seal (9) .
Illustration 7 g01329774
Install bonnet (8). Connect hose (7). Install O-ring seal (6) .
Illustration 8 g01329224
Install engine oil cooler (5). Install bolts (4) .
Illustration 9 g01329200
Install bracket (3). Connect hose (2) .
Illustration 10 g01329189
Install tube assembly (1) .End By: Install the engine oil filter base. Refer to Disassembly and Assembly, "Engine Oil Filter Base - Install".