BASE AS-FUEL FILTER 5289669 - Caterpillar

Illustration 1 g06287076
Typical example
Table 1
Item Qty Part Specification Description
1 1 504-7634 Sleeve Bearing Bore before assembly is 100.216 0.040 mm (3.9455 0.0016 inch).
Installation depth is 9.85 0.30 mm (0.388 0.012 inch).
2 1 7Y-4695 Locknut Before assembly, lubricate the face and all around the threads with 309-6932 Hydraulic Oil.
Torque to 11000 550 N m (8113 406 lb ft).
3 1 495-8212 Seal As Lubricate the inside diameter and the outside diameter with clean grease.
4 2 188-4217 Ring Lubricate the inside diameter and the outside diameter with clean grease.
5 1 188-4218 Ring Lubricate the inside diameter and the outside diameter with clean grease.
A 1 518-6326 Cylinder As Bore is 149.50 0.25 mm (5.886 0.01 inch).
B 1 518-6324 Rod As Diameter is 104.93 0.03 mm (4.131 0.001 inch).
6 1 504-7629 Sleeve Bearing Bore before assembly is 11.222 0.040 mm (0.4418 0.0016 inch).
Installation depth is 10.0 0.5 mm (0.39 0.02 inch).
7 1 Buffer Seal Lubricate the sealing lip lightly with the lubricant that is being sealed.
8 1 U-Cup Seal Lubricate the sealing lip lightly with the lubricant that is being sealed.
9 1 Lip Type Seal Lubricate the sealing lip lightly with the lubricant that is being sealed.
10 - - Before assembly, apply green Loctite 609 to the wiper seal groove.
11 1 242-6833 Seal Ring The slit must be turned in the direction of piston.
12 8 7Y-5215 Bolt Torque to 300 30 N m (221 22 lb ft).
Turn an additional angle of 30 5 degrees.
13 1 114-0760 Bushing Outside diameter is 110.148 0.033 mm (4.3365 0.0013 inch).
Thickness is 2.475 0.025 mm (0.0974 0.0010 inch).