BASE GP-OIL FILTER 5302298 - Caterpillar

start by:a) remove aftercooler housingb) remove flywheelc) remove oil pressure relief valve 1. Remove three bolts (1) from tube flange. 2. Loosen bolts (2) that hold cylinder block to oil pan base.3. Remove rear crankshaft thrower and baffle (3). See CRANKSHAFT REAR SEAL RING AND THROWER. 4. Fasten a hoist and lift engine enough to install spacers (5) on each side of oil pan base. Approximate weight of G379 is 8,000 lb. (3600 kg); G398 is 10,000 lb. (4500 kg); G399 is 13,000 lb. (5850 kg).5. Remove two bolts from flywheel housing. Install two 5/8"-11 NC bolts 6" long as a guide.6. Install tooling (A) on top of flywheel housing. Remove bolts (4), support assembly and cover from the top of flywheel housing. 7. Remove the remainder of the flywheel housing bolts (6) and flywheel housing (7). Weight of housing is 450 lb. (204 kg).8. Put 7M7260 Liquid Gasket Material on top of the housing surface that makes contact with governor drive housing. Install bolts (4) to hold cover and support assembly.9. Install tool (A) and hoist on flywheel housing. Put it in position on the cylinder block and install bolts (6).10. Install thrower. See CRANKSHAFT REAR SEAL AND THROWER.11. Fasten a hoist to engine. Lift the engine enough to remove the spacers (5). Tighten bolts.12. Install three bolts to install tube flange (1) to flywheel housing.end by:a) install flywheelb) install aftercooler housingc) install oil pressure relief valve