BASE 6V3137 - Caterpillar

Illustration 1 g00927724
Typical top view of the steering linkage
Illustration 2 g01075439
View A-A (1) Clamp assembly (2) Rod for the steering link (A) 6.350 1.530 mm (0.25 0.06 inch)
Illustration 3 g00927727
Section C-C (1) Clamp assembly (2) Rod for the steering link (3) NutNote: The opening for the clamp assembly (1) must be aligned with the slots in the rod (2) for the steering link, as shown. (3) Torque for nut ... 285 N m (210 lb ft)
Illustration 4 g01075713
View B-B (4) 8W-5396 Shim Thickness ... 1.0 mm (0.04 inch) Clearance between the top side of the steering arm and the frame ... 0.7 0.6 mm (0.03 0.02 inch)
Illustration 5 g01075511
Section D-DNote: Use 4C-5593 Anti-Seize Compound in order to lubricate the components. Lubricate the taper and the threads of the ball studs. Also, lubricate the washer face of the nuts. (5) Ball stud (6) Torque for the four nuts that are located on the ball studs (5) of the cylinder mounting ... 1360 N m (1000 lb ft) (7) Install the dust cover dry.
Illustration 6 g00927733
Typical top view of the steering cylinders
Illustration 7 g01038388
View E-E
Illustration 8 g01075514
Section F-FNote: Use 4C-5593 Anti-Seize Compound in order to lubricate the components. Lubricate the taper and the threads of the ball joint studs. Also, lubricate the washer face of the nuts. (8) Torque for four nuts that are located on the ball studs (10) of the steering linkage ... 1360 N m (1000 lb ft) (9) Install the dust cover dry. (10) Ball studNote: Refer to Testing and Adjusting, "Front Wheel - Align" for additional information.