BASE GP-OIL FILTER 7E8764 - Caterpillar

BORDER="0">
Illustration 26 g06244245
Apply Tooling (B) to O-ring (22)..
Install O-ring (22), and housing (23).
Illustration 27 g06244244
Apply Tooling (D) to needle bearings (21).
Install needle bearings (21).
Illustration 28 g06242776
Illustration 29 g06244144
Apply Tooling (D) to the shims
Install gears (20), and the shims.Note: Install the shims at location (Z) as shown in illustration 29.
Install shafts (19).
Repeat Steps 47 through 49 for the remaining gears.
Illustration 30 g06242760
Install magnet cap (18), and screws (17). Tighten screws (17) to a torque of 5 N m (44 lb in).
Illustration 31 g06236716
Install gear carrier output shaft (16).
Illustration 32 g06236705
Install thrust washers (15), and retaining ring (14).
Illustration 33 g06236687
Apply Tooling (B) to seal ring (13).
Install seal ring (13).
Illustration 34 g06236659
Install drive housing (12), and screws (11). Tighten screws (11) to a torque of 17 N m (150 lb in).
Illustration 35 g06236651
Install line (10).
Illustration 36 g06236306
Install split ring (9).
Illustration 37 g06236298
Install starting drive gear (7), and compression spring (8).
Illustration 38 g06236290
Install drive housing (6), and screws (5).Note: Check the condition of the roller bearing, replace if damaged or suspect.
Tighten screws (5) to a torque of 17 N m (12 lb ft)
Illustration 39 g06236254
Install control module (3), and the O-ring.
Install screws (2). Tighten screws (2), to a torque of 1.7 N m (15 lb in).
Install screws (2). Tighten screws (2), to a torque of 7 N m (62 lb in).
Illustration 40 g06236260
Install line (1).End By:
Install the air starting motor.