BASE 7N3096 - Caterpillar

Guidelines for Selection of a Site and the Preparation of a Site
Use the shortest cable runs possible that are consistent with logical equipment arrangements. Provide allowance for future additions if planned.
Operating temperature range is 0° C (32° F) to 40° C (104° F). Relative humidity must be less than 95% without condensation. Room Ventilation is necessary. Ensure that the environmental conditioning system can accommodate the BTU load, even during utility outages.
Ensure that the floor at the final equipment location can support the UPS weight and the weight of any material handling equipment. The UPS module can weight up to 2585 kg (5700 lb).
Ensure that the floor along the route to the installation site can support the UPS weight and the weight of any material handling equipment.
Place the system in a reasonably clean environment that is free of dust. The air must be free to circulate around the unit. Cooling air enters the unit through the front doors. The cooling air exhausts through the top of the enclosure. Adequate ventilation, including air conditioning, must be provided to limit heat accumulation in hot weather.
Avoid placing the unit in direct sunlight or near other heat sources.
Verify that the floor is a minimum of 20.7 MPa (3000 psi) concrete that can support 1.44 kN (325 lb) per square foot.
The ambient temperature for the unit must be between −20° C (−4° F) and 40° C (104° F). There is a 0° C (32° F) minimum ambient air temperature requirement for start-up of the unit. Once the UPS has been running for some time, the unit will keep warm enough in ambient temperatures as low as 0° C (32° F). However, bearing temperatures should be 20° C (68° F) or higher at start-up. Preheating of the rotor will be performed by the flywheel system if necessary for colder environments.
A clearance of 914 mm (36 inch) is required from the front of the unit for service. The sides of the system can be placed against walls. If possible, leave clearance behind the unit. Clearance behind the unit will facilitate easier cable runs. The unit vents air out of the top, therefore, the ceiling height must be a minimum of 2.4 m (8 ft). Loose ceiling tiles above the unit may be moved by the airflow.
The system should not be operated in a sealed room or a sealed container. If the system must be operated in a sealed room, climate control that meets the minimum system specifications must be provided.
If you have purchased the UPSView monitoring software, you may need to plan for the installation of an RS-232 or 485 cable. The cable must be installed from the system to the chosen local computer connection. For remote monitoring, a modem or Ethernet option and phone line or local network connection are required to interface to with UPSView.
Plan to have appropriate communication cables installed to support the remote notification and monitoring option chosen.
Electrical connections can enter through the top or bottom of the bypass cabinet.System Installation
The UPS