BASE 9S1769 - Caterpillar

Illustration 7 g06125215
(1) 475-0258 Wiring Harness
(2) 479-1744 Bracket
(3) 3S-2093 Cable Strap
Continue installing wiring harness (1) to bracket (2). Secure wiring harness (1) in place using three cable straps (3).
Illustration 8 g06125225
Disconnect and remove the seat air compressor.Note: Retain hardware to reinstall.
Assemble harness (1) and bracket (2) to the seat air compressor as shown in Illustration 8. Plug wire harness terminals on the sear air compressor at the locations shown above.Note: The orange wire connects to the terminal on the ride side of the compressor. The black wire connects to the terminal on the left side of the compressor.
Illustration 9 g06125233
(1) 475-0258 Wiring Harness
(2) 479-1744 Bracket
(3) 3S-2093 Cable Strap
Secure the black wire to bracket (2) using one cable strap (3) as shown above.
Reinstall seat air compressor to the center plate using the hardware removed in Step 4.
Torque the screws to 2.8 N m (25 lb in).
Illustration 10 g06125249
Proper spacing between the points indicated
Adjust the position of the seat air compressor to avoid contact to the metal casting. Contact with the metal casting may cause vibration during seat inflation.
Illustration 11 g06125276
Tie strap locations
(1) 475-0258 Wiring Harness
(3) 3S-2093 Cable Strap
Secure wiring harness (1) by installing two tie straps (3) to the center casting.
Illustration 12 g06125283
(1) 475-0258 Wiring Harness
(3) 3S-2093 Cable Strap
Route wiring harness (1) to the back of the center casting. Secure wiring harness (1) in place using one cable strap (3).
Illustration 13 g06125288
(F) Seat Air Switch
Locate seat air switch (F).
Pull the wires to seat air switch (F) as shown in Illustration 13.
Illustration 14 g06125307
(3) 3S-2093 Cable Strap
Secure the wiring harness to the upper housing with a push clip (fir tree).
Secure the airline and wiring harness together using one cable strap (3).
Connect red wire (G) to the angled switch contact on right-hand side of the switch.
Connect the orange wire (H) to straight contact on left-hand side of the switch.
Illustration 15 g06125316
Illustration 16 g06125345
(3) 3S-2093 Cable Strap
Check harness routing and ensure that harness is in the correct location prior to completing the assembly process.
The harness should be routed as shown in Illustration 15 and Illustration 16Note: The harness should not rub on other components as shown in Illustration 15.Seat Suspension Boot and Components Installation
Ensure Harness Assembly and Seat Suspension functions properly.
Illustration 17 g03862121
View of harness routing
Reinstall Boot and fasteners. Ensure that harness has been routed through hole in suspension boot. The rest of the harness will exit the boot.
Reinstall Seat and Seat Suspension in the machine.
Remove lock out from machine.