BASIC SEAT GROUP 2P0889 - Caterpillar

Raise console assembly (5) in order to position cover (3). Install five screws (4) into console assembly (5) .
Illustration 5 g00944956
Position the panel and install bolts (2) into the rear of the console.
Illustration 6 g00944954
Install screws (1) and install the cover onto the front of the console.
Fill the hydraulic oil tank with clean hydraulic oil to the correct level. Refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check" for the correct filling procedures. Refer to Operation and Maintenance Manual, "Lubricant Viscosities" for the proper oil viscosity.
Install the cap onto the hydraulic tank.
Start the engine, and check the operation of the joystick. Also, check for leaks. Stop the engine.Right Hand
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
A     5P-0306     Vacuum Transducer     1    
FT-1115 Vacuum Cap     1    
6V-4142 Fitting     1    
5K-5068 Fitting     1    
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 7 g00975530
Place pilot valve (7) into position, as shown. Install bolts (10). Connect harness assembly (9) .
Illustration 8 g00975525
Connect hose assemblies (8) onto pilot valve (7) .
Illustration 9 g00944947
Remove Tooling (A) .
Illustration 10 g01162074
Install knob (6) .
Illustration 11 g00975523
Raise console assembly (5) in order to position cover (3). Install five screws (4) into console assembly (5) .
Illustration 12 g01162075
Position the panel and install screws (2) into the rear of the console.
Illustration 13 g00975433
Install screws (1) and install the cover onto the front of the console.
Fill the hydraulic oil tank with clean hydraulic oil to the correct level. Refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check" for the correct filling procedures. Refer to Operation and Maintenance Manual, "Lubricant Viscosities" for the proper oil viscosity.
Install the cap onto the hydraulic tank.
Start the engine, and check the operation of the joystick. Also, check for leaks. Stop the engine.