BASKET 0828544 - Caterpillar

Removal Procedure
Start By:
Remove the turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Remove".
Remove the air inlet manifold. Refer to Disassembly and Assembly, "Air Inlet Manifold - Remove and Install".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00636603
Illustration 2 g00636605
Remove exhaust manifold bolts (2) in reverse order of the numbered sequence.
Remove exhaust manifold (1) from the engine.
Illustration 3 g00557351
Typical example
Remove exhaust manifold gaskets (3) from the cylinder head.
Remove old sealant from stud threads.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 4 g00557351
Typical example
Inspect the condition of the gaskets. If the gaskets are damaged, use new parts for replacement. Install exhaust manifold gaskets (3) on the cylinder head.
Illustration 5 g00636603
Illustration 6 g00636605
Damage to the exhaust manifold can occur if the exhaust manifold is not aligned and tightened correctly.
Install exhaust manifold (1) on the cylinder head.
Apply 4C-9507 Retaining Compound to the bolts for the exhaust manifold before assembly. Install exhaust manifold bolts (2). Tighten the bolts for the exhaust manifold in the numerical sequence to a torque of 44 N m (33 lb ft).End By:
Install the air inlet manifold. Refer to Disassembly and Assembly, "Air Inlet Manifold - Remove and Install".
Install the turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Install".